Operating Check List - Land Pride Z48 Operator's Manual

Section 2: Operating Procedures

Operating Check List

Hazard control and accident prevention are dependent
upon awareness, concern, prudence and proper training
involved in operation, transport, maintenance and
storage of the riding mower. Therefore, it is absolutely
essential that no one operates the mower without first
having read, fully understood and become totally familiar
with the Operator's Manual. Make sure the operator has
paid particular attention to:
•
Important Safety Information, page 1
•
Section 1: Assembly & Set-up, page 10
•
Section 2: Operating Procedures, page 13
•
Section 3: Adjustments, page 23
•
Section 5: Maintenance & Lubrication, page 31
The following Operating Checklist should be performed
before operating your mower:
Operating Checklist
Check
Carefully read and follow all Safety Rules.
Refer to "Important Safety Information".
Make sure all guards and shields are in place.
Refer to "Mower Features".
Make all required adjustments.
Refer to "Section 3: Adjustments".
Read and follow all operating procedures.
Refer to "Section 2: Operating Procedures".
Check mower safety start interlock system daily
prior to operation.
Perform all Maintenance and Lubrications.
Refer to "Section 5: Maintenance &
Lubrication".
Make sure their are no hydraulic leaks on the
unit. Refer to "Avoid High Pressure Fluids
Hazard".
Check blade for nicks and sharpness.
Refer to "Mower Blade Maintenance".
Check mower initially and periodically for loose
bolts and pins. Refer to "Torque Values Chart".
Instrumentation
Engine Oil Pressure Light
Refer to to Figure 2-2:
This light comes on when ignition switch is placed in RUN
position and stays lit until the engine is running with safe
oil pressure. Shut engine off immediately if light comes
on during operation. Locate and correct problem before
using the mower.
Hour Meter
Refer to Figure 2-2:
The hour meter registers 1/10 hour increments up to
9,999.9 total hours. The meter is connected to the ignition
switch and records accumulative time only while the
engine is running.
A plastic film covers the hour meter window. It protects
the window from scratches during shop assembly and
14 Z48, Z54, ZSR54 & ZSR60 Accu-Z Razor
Table of Contents
shipping. This covering should be removed by the owner
before placing mower into service.
Controls
Refer to Figure 2-1 on page 13 and Figure 2-2 below for
general location of controls described in this section.
!
Do not operate mower while smoking!
Ignition Switch
Refer to Figure 2-2:
A three position ignition switch: off, run, and start is
provided. With key inserted, rotate it clockwise to START
position; release key when engine starts and switch will
automatically return to RUN position. Turn key
counterclockwise to OFF position to stop engine.
Throttle
Refer to Figure 2-2:
A cable is linked from engine to throttle for controlling
Referenc
engine speed. Move throttle lever forward to increase
engine rpm and rearward to decrease rpm. Always travel
Page 1
and cut grass with throttle set at full engine rpm speed.
Page 13
Decrease travel speed by pulling back on the control
levers. Reduce engine rpm only when mower is not
traveling and just before engaging the cutting blades.
Page 23
Page 13
IMPORTANT: Always operate throttle at full engine
Page 17
rpm speed while traveling or cutting grass.
Operating the engine at a slow rpm may overheat
the engine and hydraulic pumps.
Page 31
Page 2
Page 46
Page 58
Engine Oil
Pressure Light
®
Zero Turn Mowers 357-344M
WARNING
Blade
Engagement
Switch
Ignition Switch
Hour Meter
Choke
Control Panel
Figure 2-2
Throttle
23686
11/05/10