5. Remove the TP-45 board. (Refer to Section 2-1-8.)
6. Remove the two screws, then remove the inverter unit.
7. Remove one screw, then disconnect the harness.
8. Remove the two screws, then remove the LCD
module.
9. Remove the flexible printed wiring board from the
connector (CN1) on the LCD module.
Flexible flat
cable
Inverter unit
PTP
2x5
CN1
LCD front cabinet assembly
10. Attach the LCD module in the reverse order of steps 1
to 9.
2-12
LCD module
PTP 2x5
Harnes
PTP
2x5
TP-45 board
Flexible printed
wiring board
DPP-EX7 V1