Low Battery Power Detection; Key Lock - Montigo L52DF-ST Installation & Maintenance Manual

Continuous Pilot (CPI) Selection (Optional)
In cold weather climates, the pilot burner can stay on continu-
ously to prevent condensation or cold air temperatures near
the fireplace glass. Note, some jurisdictions do no permit use
of continuous pilot system. Check local codes or contact your
Montigo dealer.
With the system in "off" position press the Mode Key, see Figure
20, to index to the CPI mode icon, see Figure 20n. Pressing the
Up Arrow Key will activate the Continuous Pilot Ignition mode
(CPI). Pressing the Down Arrow Key will return to IPI. A single
"beep" will confirm the reception of the command.
NOTE:
- Requires CPI/IPI jumper cable installed, see page 17.
Figure 20n. Continuous Pilot / Intermittent Pilot Selection

Key Lock

This function will lock the keys to avoid unsupervised operation.
To activate this function, press the Mode and Up Keys at the
same time, see Figure 20o. To de-activate this function, press the
Mode and Up Keys at the same time.
Figure 20o. Key Lock
XG0811 - 151126
Operation

Low Battery Power Detection

The life span of the batteries depends on various factors: quality
of the batteries used, the number of ignitions of the appliance,
the number of changes to the room thermostat set point, etc.
Remote Control
When the Remote Control batteries are low, a Battery Icon will
appear on the LCD display of the Remote Control, see Figure
20p, before all battery power is lost. When the batteries are
replaced this icon will disappear.
Figure 20p. Low Battery Power Detection
Control Module
When the back-up batteries are low, a "double-beep" will be
emitted from the IFC when it receivers an On/Off command from
the Remote Control. This is an alert for a low battery condition of
the receiver and after that no more commands will be accepted.
When the batteries are replaced the "beep" will be emitted from
the receiver as soon as powered.
L52DF*ST Indoor Gas Fireplace
Page 29