Carburetor; Removing The Carburetor; Assembly - Dolmar PS-6100 Repair Manual

08 CARBURETOR

2
1

Removing the carburetor

CAUTION: Completely empty the fuel tank
before disassembling the carburetor!
Remove the cover and air  lter. Remove
the air  lter base, see Chap. 07 under
Combination switch.
Remove the pulse line 1, fuel line (red) 2 and
primer suction line 4 from the carburetor.
CAUTION: There is fuel in the line. Catch
escaping fuel with a cloth.
Disengage the throttle cable 3.
Pull the carburetor and air  ap off the
stationary bolts and then disengage the air
 ap linkage 6 from the carburetor.
Repair Manual PS-6100 / PS-6100 H
3
2
4
1

Assembly

Place the insert 5 in the intake manifold if
necessary.
Engage the air  ap linkage 6, see illustration.
Note: Engage the air  ap linkage 6 on the
carburetor in the throttle  ap actuator on the
carburetor side.
Push the carburetor and air  ap onto the
stationary bolts.
Connect the primer suction line 4 to the
carburetor.
Connect the pulse line1 and fuel line (red) 2,
and then connect the throttle cable 3.
Position the carburetor and air  ap with the
red side on the outside.
5
4
6
Before installing the air  lter base, see Chap.
07 under Combination switch, and engage
the choke linkage 7 in the choke valve
actuator on the carburetor.
7
19