Fault Log - 3Com 1000 User Manual

Fault Log

6-9
Fault Log
The Fault Log displays read-only information about
the Switch which is updated whenever an abnor-
mal condition is detected. This information is for
internal 3Com use only. You may be asked to
quote this information if reporting a fault to your
supplier.
With the Status screen displayed, select the FAULT
LOG button. The Fault Log screen is displayed, as
shown in Figure 6-6.
Figure 6-6 Fault Log screen
The Fault Log screen shows the following:
Reset Count The number of resets recorded at the
time of the fault.
Time (seconds) The time elapsed since the last
reset when the fault occurred.
Area This information may be used for fault diagno-
sis by your technical support representative.
Fault Number The hexadecimal number in this field
indicates the type of fault. You should note this
number and contact your technical support repre-
sentative for advice.