Toro TimeCutter Z4235 Operator's Manual page 38

3 3
6
Figure 50
1. Hanger bracket
2. Rear locking nut
3. Side locking nut
Adjusting the Front-to-Rear Blade
Slope
Check the front-to-rear blade level any time you install
the mower. If the front of the mower is more than
5/16 inch (7.9 mm) lower than the rear of the mower,
adjust the blade level using the following instructions:
1. Park the machine on a level surface and disengage
the blade control switch.
2. Move the motion control levers outward to the
park position, stop the engine, remove the key, and
wait for all moving parts to stop before leaving the
operating position.
3. Set the height-of-cut lever to middle position.
Note: Check and adjust the side-to-side blade
level if you have not checked the setting; refer to
Side-to-Side Leveling.
4. Carefully rotate the blades so they are facing front to
rear (Figure 51 and Figure 52).
4
1
2
5
G005074
4. Eccentric adjustment plate
5. Socket wrench hole
6. Socket wrench with 3/8
inch extension
Mower Decks with 2 Blades
1. Blades front to rear
2. Measure from the tip of the blade to the flat surface here
3
G009659
Mower Decks with 3 Blades
1. Blades front to rear
2. Outside cutting edges
5. Measure from the tip of the front blade to the flat
surface and the tip of the rear blade to the flat surface
(Figure 51 and Figure 52). If the front blade tip is
not 1/16-5/16 inch (1.6-7.9 mm) lower than the rear
blade tip, adjust the front locknut.
6. To adjust the front-to-rear blade slope, rotate the
adjustment nut in the front of the mower (Figure 53).
1. Adjusting rod
2. Adjusting block
38
Figure 51
2
1
Figure 52
3. Measure from the tip of the
blade to the flat surface
here
Figure 53
3. Lock nut
2
3