Install The Hardware; Install The Wall Mount; Route The Network Cable Through The Cable Hole - Axis Q1614-E Installation Manual

AXIS Q1614-E Network Camera

Install the Hardware

Install the Wall Mount

CAUTION
Make sure that the screws and plugs are appropriate for the material (e.g. wood, metal,
drywall, stone) and that the material is strong enough to support the combined weight
of the camera, housing, and wall mount.
Note
• See also the wall mount's Installation Guide supplied in the package and available on
www.axis.com
• For technical specifications about the connectors, see the camera's User Manual available
on www.axis.com
1. Prepare the wall for installation of the wall mount. Use the wall bracket as a template
and mark the holes before drilling the holes.
2. Route the network cable and, if required, the power cable through the wall bracket.
Leave approximately 30 cm (11.8 in) of cable for connecting the camera.
3. If connecting an auxiliary device, for example an I/O, audio, or external power device, to
the camera, repeat the step above as applicable to the specific device.
4. Fasten the wall bracket to the wall by tightening the screws.

Route the Network Cable Through the Cable Hole

NO TICE TICE
NO NO TICE
Using any other than the provided cable gland may cause water to seep in and damage
the product. Cables must have a diameter of 4.0–5.5 mm.
Note
Check against the hardware overview image (see page 10) while following the steps below.
20