Miele KM 452 Installation Instructions Manual page 6

Appliance and cut-out dimensions
KM 452
iI
,7 Spring clips
,_2 _
,_There must be at least ,'3,'3/ ,, (81ram)
J16
of usable depth on the right side of
the cut ouL
[] Make the countertop cut-out following
the dimensions given in the
illustration.
[] Remember to maintain a minimum
distance of 2" (50) mm between the
rear watl and a right or left hand side
wa!l. See also "Important Safety
instructions".
[] Seal the cut surfaces with a suitable
sealant to avoid swelling caused by
moisture. The materials used must be
heat resistant.
If, during installation, the seal around [:
the frame does not sit flush with the
countertop on the corners, ,!he il
ii corner radius max. R4 (s/16) can be _