Before First Use; Operation - Morphy Richards Coffeemaker User Manual

45076 rev1 22/3/07 08:52

BEFORE FIRST USE

Refer to the assembly sequence
in section
'Assembly/disassembly
sequence'.
When unpacking the fryer, make
sure all packaging material is
removed.
WARNING: make sure that
your fryer is disconnected
from the electricity supply.
Please note: Remove the filter
from the lid before washing lid.
Remove the oil storage
container, ladle, frying basket,
non stick oil tank, lid, body and
wash these by hand in hot
soapy water. Please note: do not
leave in water to soak for a long
period of time.
WARNING: Do not immerse
the control panel in water.
Dry all parts of your fryer
thoroughly and replace the oil
tank, basket and lid.
Replace the oil tank with the
max/min lines to the rear.
(Please follow the cleaning
instructions).

OPERATION

Lid operation
Press the lid release button, the
lid is spring loaded and will rise
up on its own A.
In the upper position the lid will
lift out of its guides at the back
for easy cleaning.To replace,
locate in the guides and slide
back into position.
Close the lid by pressing down
in the centre and ensure locking
catch „ is fully engaged B.
Attaching the handle
to a basket
Rest the basket on a level, firm
surface, locate the handle into
the slots of the basket and pull
upwards against the spring
force C.
6 6
Page 6
Removal of handles
Rest the basket on a level, firm
surface, press the handle down
against the spring force and
remove D.
Basket operation
The handles are removable so
they can be attached to the
basket D.
Location of basket to
drain
With the lid open and in the
vertical position, the basket can
be raised into the rest draining
position or removed completely
E.
When in the draining position
the basket should be hooked on
the basket rest lip (shown by the
arrow). When lowering the
basket back, lift up to remove
from the basket rest position,
push forward slightly and lower
down. Press the basket release
button and allow the handle to
lower.
When using the basket, both
basket release buttons must be
pressed to allow the basket to
lower into the oil F.
Assembly/
Disassembly
sequence
The fryer has to be
disassembled and assembled
following this procedure.
• Open the lid and remove.
• Remove the basket.
• Lift out the tank.
• Pull out the control panel.
Assembly is the reverse of the
above process.
A
B
C
D
E
F
4 4