Sony SRG-120DH Operating Instructions Manual page 9

J LAN connector (RJ-45 8-pin)
Connect to a switching HUB that is
compatible with 10BASE-T/100BASE-
TX using a LAN cable (category 5 or
higher, shielded twisted pair).
When a link is established, the green
indicator lights, and it flashes during
communication. While connected with
100BASE-TX, the yellow indicator also
lights.
CAUTION
For safety, do not connect the connector
for peripheral device wiring that might
have excessive voltage to this port.
Follow the instructions for this port.
K DC 12 V connector
Connect the supplied AC power adaptor.
L Reset switch
The reset switch is available only when
LAN is set. If you press this switch with
a pointed tip for about five seconds, the
camera will reboot and the IP settings
will return to the factory default.
Factory settings for IP
IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Name: CAM1
Bottom
M BOTTOM switches
Used for LAN and VISCA CONTROL
switching, 9,600 bps and 38,400 bps
baud rate selection and IR signal output
setting.
For details, refer to the setting of the
BOTTOM switches (page 10).
N Tripod screw hole (1/4-20UNC)
When you use a tripod screw, use this
screw hole to fix it.
O Mounting screw hole (M3)
Use this hole to secure a bracket, etc.
Setting of the SYSTEM SELECT
switch
This switch allows you to select the video
format of the signal to be output from the
HDMI video connector.
SRG-120DH
Switch Video format
position
0 1920×1080p/59.94
1 No output
2 1920×1080p/29.97
3 1920×1080i/59.94
4 1280×720p/59.94
5 1280×720p/29.97
Location and Functions of Parts and Controls
Set this arrow to the
desired video format.
59.94 Hz
system
9