Sony SRG-120DH Operating Instructions Manual page 10

Switch Video format
position
EDID
6
VISCA CONTROL
7
8 1920×1080p/50
9 No output
A 1920×1080p/25
B 1920×1080i/50
C 1280×720p/50
D 1280×720p/25
E No output
No output
F
Notes
• Be sure to set this switch before you turn
on the power of the camera. You can also
set this switch in the standby mode of the
camera. After completing the setting, turn
on the power of the camera by connecting
it to an AC outlet using the supplied AC
power adaptor and AC power cord, by
using the VISCA command or infrared
remote commander.
• Be sure to use a Phillips-head screwdriver
when changing the switch position. If you
use a tool other than the designated
screwdriver, the crossed groove may be
damaged.
• If the switch position is set to 1, 9, E or F
(no output), the POWER lamp and
STANDBY lamp will both remain lit. In
such cases, control via the infrared remote
commander and VISCA commands is
disabled.
• If the switch is set to EDID, the most
suitable format will be output
automatically based on the resolution of
the TV monitor to be connected.
• If the switch position is set to 7 (VISCA
CONTROL), you can configure the video
format via external communication.
For detailed information, refer to the
Technical Manual of the camera. For details
on obtaining a Technical Manual, consult
your Sony dealer.
10
Location and Functions of Parts and Controls
Setting of the BOTTOM switches
To change the setting of the BOTTOM
switches, turn off the camera (unless it is in
–
standby mode) first, set the BOTTOM
–
switches, then turn on the camera again.
Changing the BOTTOM switches is not
possible while the camera is turned on.
50 Hz
system
ON
–
OFF
–
A VISCA/LAN switch
Select the control setting.
Set to ON to use the LAN connection
and set to OFF to use the VISCA
CONTROL (RS-232 serial control).
B Switch 2 (Not used)
Be sure to set this switch to OFF.
C BAUD RATE SELECT switch
(when using the serial
connection)
Set the communication speed in the
VISCA CONTROL.
ON: 38,400 bps
OFF: 9,600 bps
D IR OUT switch
Set to ON to enable output of the
receiver signals, which are transmitted
from the infrared remote commander via
the VISCA IN connector (page 40), or
set it to OFF to disable the output.
E Switch 5 (Not used)
Be sure to set this switch to OFF.
F Switch 6 (Not used)
Be sure to set this switch to OFF.
G Switch 7 (Not used)
Be sure to set this switch to OFF.
H Switch 8 (Not used)
Be sure to set this switch to OFF.
OFF: Default position