If A Message Appears - Roland XC-540 User Manual

7-7 If a Message Appears

These are the main messages that appear on the machine's
display to prompt correct operation. They do not indi-
cate any error. Follow the prompts and take action ac-
cordingly.
[1I 2I 3I 4I ...]
Only a small amount of ink remains. Replace the cartridge
indicated by the flashing number with a new cartridge.
[PRESS POWER KEY TO CLEAN]
This appears when the machine has been unused for about
one month.
This feature is to remind you to switch on the sub power
once a month.
P. 78, "When Not in Use for a Prolonged Period"
[SET SOL CRT.]
Insert the ink cartridge indicated by the flashing number.
This message appears at times such as during cartridge re-
placement.
[REMOVE SOL CRT.]
Remove the ink cartridge indicated by the flashing number.
This message appears at times such as during cartridge re-
placement.
[SET SOLCL-LIQUID]
Insert the cleaning cartridge indicated by the flashing num-
ber. This message appears at times such as during head
cleaning.
[REMOVE SOLCL-LIQUID]
Remove the cleaning cartridge indicated by the flashing
number. This message appears at times such as during head
cleaning.
[SET CARTRIDGE.]
Insert the ink cartridge indicated by the flashing number.
This message appears at times such as during cartridge re-
placement.
[END OF THE SHEET]
The trailing edge of the media was detected during opera-
tion. Press any button on the operation panel to clear the
message. Load new media.
[SHEET NOT LOADED PRESS SETUP KEY]
Load media and press
an attempt to perform a printing test was made while no
media was loaded.
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain
bottle, then press .
. This message appears when
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged fluid
collects in the drain bottle. To clear the message, press
. If this screen appears, go to the [DRAIN BOTTLE]
menu and discard the discharged fluid in the bottle.
P. 62, "Disposing of Discharged Ink"
[NOW HEATING...]
Wait until the media heating system reach the preset tem-
perature. Printing starts when
You can stop printing by holding down
second or longer while this is displayed. Pressing
makes printing start immediately, without waiting to reach
the preset temperature.
[CLOSE THE FRONT COVER]
Close the front cover.
For safety, the carriage does not operate while a cover is
open.
[SET HEAD HEIGHT TO xxx]
The height of the print heads is lower than the height speci-
fied on the computer.
The heads move to a location where you can operate the
height-adjustment lever. Adjust to the displayed height, then
press .
[REMOVE MEDIA CLAMPS]
This appears if is pressed while the media clamps
are attached. Remove the media clamp and press
[TIME FOR MAINTENANCE]
It is time to clean the heads using the cleaning kit. After
verifying, press .
P. 68, "Cleaning the Heads Using the Cleaning Kit"
[TIME FOR WIPER REPLACE]
It is time to replace the wipers. After verifying, press
P. 72, "Replacing the Wipers"
Chapter 7 What to Do If
lights up.
for one
.
.
137