Replacement Of Receiver Section Of Wireless Remote Controller - Daikin Sky Air B-Series R-410A Service Manual

Si21-205
1.14 Replacement of Receiver Section of Wireless Remote
Controller
Procedure
Step
1. Removing the receiver
section
1 Remove two screws of
the transmission parts
box to remove the box.
2 Cut the tie wrap fixing
transmission parts box
and harness and
disconnect the
connector X1A.
3 Disconnect the lead
wire of the transmission
parts box from the
connector X24A on the
indoor unit PC board.
4 Removing the
decoration panel
Refer to the
"Removal of
Decoration Panel"
5 Pull out the lead wire of
receiver section from
wiring groove.
6 Push three claws on the
rear side of panel to
remove the corner
cover (receiver
section).
Removal Procedure
Warning Be sure to wait 10 minutes or more after turning off all power supplies
before disassembling work.
Procedure
(S2696)
(S2697)
X24
(S2694)
Tie wrap
Lead wire of receiver section
Decoration panel
(S2699)
FFQ25/35/50/60BV1B
Points
Transmission parts box
(S2695)
Push three claws to remove
the corner cover.
(S2698)
253