Pioneer PDP-5050SX Operating Instructions Manual page 9

Safety Precautions
Installation Precautions
Observe the following precautions when installing with any items such as the optional stand.
When using the optional stand, brackets, or equivalent items
• Ask your dealer to perform the installation.
• Be sure to use the supplied bolts.
• For details, see the instruction manual that comes with the optional stand (or equivalent items).
When using other items
• Consult your dealer.
• The following six mounting holes can be used for the installation:
Rear view
Mounting hole
• Be sure to use four or more mounting holes symmetrical to the vertical and horizontal median lines.
• Use M8 screws, which go 12 to 18 mm (1/2 to 11/16 inches) in depth from the mounting surface of the Plasma Display. See the
side view above.
• Be careful not to block the ventilation opening at the rear of the Plasma Display.
• Be sure to install the Plasma Display on a flat surface because it contains glass.
• The screw holes other than the above are to be used only for the specified products. Never use them for mounting non-specified
products.
• Do not mount or remove the Plasma Display to or from the stand, with speakers attached.
• It is strongly recommended to use the optional PIONEER mounting products.
• PIONEER shall not be liable for any personal injury or product damage that results from the use of mounting items other than the
optional PIONEER products.
04-PDP5050SX-Eng (06-11)
Median line
9
Side view
Mounting hole
Median line
05.2.25, 9:50 AM
Mounting surface
Mounting
Plasma bracket (or
Display equivalent item)
M8 screw
12 to 18 mm
(1/2 to 11/16 inches)
02
9
En