Table of Contents
Advertisement
up050.fm Page 5 Tuesday, October 5, 2004 4:12 PM
Receiving a call
If the handset is in the base, simply remove the handset from the base. AutoTalk will
automatically answer the call.
If the handset is off the base, press the talk key or any number key.
Hanging up
Press the end key or return the handset to the base.
Redialing the last dialed number
1) Remove the handset from the base.
2) Press the talk key. The talk/batt low LED flashes and turns on.
3) Listen for the dial tone.
4) Press the redial/pause key.
Flash and Call Waiting
If you have "Call Waiting" service and a call waiting tone sounds while
you are on a call, press the flash key to accept the waiting call. There
is a short pause. Then you will hear the new caller. To return to the
original caller, press the flash key again.
NOTE:You must subscribe through your local telephone company to
receive Call Waiting service.
Adjusting the Ringer and Earpiece Volume
Ringer tone and volume
When the phone is in standby mode, press the vol/
ringer tones and volume combinations. The last ringer tone heard will be selected as the
phone's ring tone setting.
Earpiece volume
The handset earpiece volume settings can only be adjusted during a call. Press the vol/
key repeatedly to scroll between and select the volume level that works best for you. When
you hang up, the phone keeps the volume setting.
Temporarily Mute Ringer
If the handset is off the base, simply press the end key to temporarily mute the incoming ring.
The ringer will sound with the next incoming call.
Traveling Out-of-Range
During a call, as you begin to move your handset too far from your base unit, noise increases.
If you pass the range limits of the base unit, your call will terminate within one minute.
Selecting a Different Channel
If you encounter interference while using your phone, you can manually change the phone's
channel for clear operation. This function works only when the phone is in use.
Press the channel key. The talk/batt low LED flashes, indicating the phone is changing to
another channel. For more information on interference, refer to "Precautions" on page 10.
Find Handset
To locate the handset, press the find handset key on the base. The handset beeps for 60
seconds. The handset stops beeping when any key is pressed, when it is returned to the base,
or when the find handset key is pressed. The handset also stops beeping when an incoming
call is received.
Low Battery Alert
When the battery pack is very low and needs to be charged, the phone is programmed to
eliminate functions in order to save power. If the phone is not in use, the talk/batt low LED
flashes when the battery pack is low.
key repeatedly to listen to the four
5
Advertisement
Table of Contents
