Switching The Projector On/Off; Mains Lead; Power Indicator - Panasonic PT-AE1000E Operating Instructions Manual

Switching the projector on/off

Mains lead

Ensure all the input devices are connected and turned off before connecting the Mains lead.
Connecting
Make sure to use the
Mains lead which is
provided with the projector.
1. Ensure the shape of the
mains plug and the AC
IN connector on the side
of the projector match, then push the plug all
the way in.
2. Connect the Mains lead to a wall socket.
NOTE:
Do not force the connector as this may damage the projector and/or the mains lead.
Dirt or dust build-up around plugs may cause fire or electrical hazards.
Switch off the power to the projector when not in use.

POWER indicator

POWER indicator
Indicator status
No illumination or flashing
RED
Flashing
GREEN
ORANGE
Flashing
NOTE:
While the projector is cooling the lamp, do not switch the MAIN POWER off or unplug the Mains lead.
The electric consumption in standby mode is 0.08 W.
The MAIN POWER is switched off.
Lit The MAIN POWER is switched on and the projector is in standby.
The POWER is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
Lit The POWER is switched off and the projector is cooling the lamp.
The POWER is switched on again when cooling the lamp and recovering
to projection mode. Recovery may take a while.
Disconnecting
Make sure the
MAIN POWER
1. Hold the plug and unplug the Mains lead
from the wall socket.
2. Hold the plug and unplug the Mains lead
from the AC IN connector on the side of the
projector.
Status
is switched off
.
E - 19
NGLISH