Instructions For Attaching A Vesa Compliant Arm - Samsung LL-T15G1 Operation Manual

Instructions for attaching a VESA compliant arm

An arm based on the VESA standard can be at-
tached to the monitor. The arm must be purchased
separately.
When choosing the arm to be installed please take
note of the following points.
- The arm should be compatible with the VESA
standard, and there must be a gap of 75mm x
75mm between the screw holes on the section to
be attached.
- The arm must not fall off or break off after being
attached to the monitor.
Note:
- Do not overly bend the cable or add extension
cords as this could lead to malfunction.
1. Ensure that both the monitor and computer are
switched off.
2. Remove the AC adapter and the RGB signal
cable.
3. Press down on the stand and gently fold back the
monitor.
Be sure to completely fold the monitor back to
stopping point.
If it is attempted to install the arm while the
monitor is not completely folded back, the
monitor may suddenly fall, leading to malfunction.
Be careful not to pinch your fingers.
4. Being careful not to damage the monitor, spread
out a soft cloth and lay the monitor on it display-
side down.
5. Attach the arm to the monitor with four screws.
The screws used to
attach the arm should be
M4 screws with a length
of 4 mm ~ 6 mm protrud-
ing from the surface to be
attached. Using any other
kind of screw may lead to
the monitor falling off or
damage to the internal
part of the monitor.
6. Connect the AC adapter and the RGB signal
cable.
26
4 ~ 6 mm
Screw used to
attach arm
Arm
Part of monitor to
which arm is
attached