Advertisement
Getting started
Adding and registering handsets
NOT REGISTERED
PRESS
HNDST LOC
4 SEC ON BASE
PLEASE WAIT...
HS X
REGISTERED
12:00PM
Before using a new E598- handset, you
must register it with the telephone base.
Each handset must be registered seper-
ately.
To ��egis��e�� a �an�se�� ��o you�� ��elep�one
base
When first purchased, the expansion hand-
set will show NOT REGISTERED on the
screen. The new handset may need to be
charged for five minutes before registering
to the main telephone base.
. Place the unregistered handset into the
telephone base. If PRESS HNDST LOC 4
SEC ON BASE does not appear on the
handset screen after a few seconds, lift
up handset and place it in the telephone
base again.
. On the telephone base, press and hold
HANDSET LOCATOR for about four
seconds (until the red IN USE light
on the telephone base turns on) and
then release the button. The handset
will show PLEASE WAIT.... and will
take about 0 seconds to complete
the registration. The handset will show
HS X REGISTERED and will beep if the
registration was successful.
NOTES:
. If the registration was not successful the display
will show NOT REGISTERED. To reset the hand-
set, lift the handset out of the telephone base
or charger and replace it. Try the registration
process again.
. You cannot register a handset if any phone con-
nected to your phone line is in use.
4
Advertisement
