Razor Ground Force Drifter 25143400 Owner's Manual page 6

ASSEMBLy AND SET-UP
Turn power switch off before conducting any maintenance procedures.
q Replacing the Wheels
Front and rear wheel installation and removal are the same.
Loosen
Tighten
1
To remove a wheel, remove the
self-locking nut (13mm socket or
wrench required for front wheels,
17mm for the rear wheels). Tap the
wheel to remove.
q Replacing the Chain
1
Remove the rear wheel.
4
Remove c-clips on the axle
between the two bearings.
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
2
To replace a front wheel, make
sure the bearings are seated and
the center spacer is installed. Posi-
tion the wheel with the Razor logo
facing outward. Install the washer
and tighten the self-locking nut
securely.
2
Use a 3mm wrench to loosen
the brake.
5
Lightly tap the end of the axle
with a rubber mallet. DO NOT USE
A HAMMER as this will damage the
thread. The brake drum and pulley
must be slid along the axle as your
tapping progresses.
2
To replace a rear wheel, make
sure the key is properly seated in
the rear axle and aligned with the
key in the wheel. Position the wheel
with the Razor logo facing outward.
Install the washer and tighten the
self-locking nut securely.
3
Use a 3mm wrench to loosen the
sprocket.
6
When the axle end is clear of
the bearing hanger, remove and
replace the chain. Reverse this
procedure to reassemble.
5
WARNING: Failure
to properly adust and tighten the
screws, nuts and bolts that affix
the wheels can cause you to lose
control and crash.
Note: The Ground Force Drifter
wheels must be replaced when worn
down to the wear indicator line.
Note: Practice drift driving only in
wide open areas clear from curbs,
parking blocks and other obstacles.
Impacting the wheels against
any hard surface can damage the
wheels. Wheels are not covered
under your limited warranty.