Pioneer DEH-P7000BT Operation Manual page 84

C_C_o_"_"_e_c_t i _"-=-Q_t_he_u_"_it__)
C~
E_"---=Q=------I
i _sh~)
• When this unit is installed in a vehicle without
ACC (accessory) position on the ignition switch,
red cable must be wired to the terminal that can
detect the operation of the ignition key. Otherwise,
battery drain may result.
• Control signal is output through blue/white cable
when this unit is powered on. Connect
it
to an
external power amp's system remote control or
the vehicle's auto-antenna relay control terminal
(max. 300 mAo 12 V DC), If the vehicle is equipped
with a glass antenna, connect it to the antenna
booster power supply terminal,
• Never connect blue/white cable to external power
amp's power terminal. Also, never connect
it
to the power terminal of the auto antenna.
Otherwise, battery drain or malfunction may
result.
• IP-BUS connectors are color-coded. Be sure to
connect connectors of the same color,
• Black cable is ground. This cable and other
product's ground cable (especially, high-current
products such as power amp) must be wired
separately, Otherwise, fire or malfunction may
result if they are accidentally detached.
No ACC position ACC position
• Use this unit in other than the following
conditions could result in fire or malfunction.
- Veh icles with a 12volt battery and negative
grounding.
-Speakers with 50 W (output value) and 4 ohm
to 8 ohm (impedance value),
• To prevent short-circuit, overheating or
malfunction, be sure to follow the directions
below.
- Disconnect the negative terminal of the
battery before installation.
-Secure the wiring with cable clamps or
adhesive tape. To protect the wiring, wrap
adhesive tape around them where they lie
agai nst metal parts.
-Place all cables away from moving parts, such
as gear shift and seat rails.
- Place all cables away from hot places, such as
near the heater outlet.
-Do not pass the yellow cable through a hole
into the engine compartment to connect to a
battery.
-Cover any disconnected cable connectors with
insulating tape,
- Do not shorten any cables,
-Never cut the insulation of the power cable of
this unit in order to share the power to other
equipment. Current capacity of the cable is
limited.
- Use a fuse of the rating prescribed.
- Never wire the speaker negative cable directly
to ground.
-Never band together multiple speaker's
negative cables.