Section
(_O_p_e_ra_t_in_g_t_h_is_u_n_it
~)
•
•
If the difference between the ring volume and
caller's voice volume is big, overall volume level
may become unstable.
•
Before disconnecting the cellular phone from
this unit, make sure to adjust the volume to a
proper level. If the volume is muted (zero level) on
your cellular phone, the volume level of your cel-
lular phone remains muted even after the cellular
phone is disconnected.
UNotes
• The equalizer curve for the phone source is
fixed.
•
When selecting the phone source, you can
only operate FADER (balance adjustment) in
the audio menu.
•
When selecting the phone source, the fader
value is set to FADER:F15 as an initial setting.
Introduction of connection and
registration
1
Press MULTI-CONTROL to display the
main menu.
2
Use MULTI-CONTROL to select
CONNECTION.
The connection menu is displayed.
Turn to change the menu option. Press to se-
lect.
•
You can also select this menu by pressing and
holding
PHONE/~/CONNECT
on the ordinary
display.
3
Turn MULTI-CONTROL to select the
function.
PAIRED PHONE (pai red phone)-
8T HANDS FREE (new phone)-SET PHONE
(phone registration)-DISCONNECT PHONE
(disconnect phone)-DELETE PHONE (delete
phone)
If the phone is not connected and not
paired
The following function can be operated.
•
8T HANDS FREE (new phone)
If the phone is not connected but paired
The following functions can be operated.
•
PAIRED PHONE (pair phone manually)
• 8T HANDS FREE (new phone)
•
DELETE PHONE (delete phone)
If the phone is connected but not paired
The following functions can be operated.
• SET PHONE (phone registration)
•
DISCONNECT PHONE (disconnect phone)
•
DELETE PHONE (delete phone)
If the phone is connected and paired
The following functions can be operated.
•
DISCONNECT PHONE (disconnect phone)
•
DELETE PHONE (delete phone)
UNotes
• The device name is set to PIONEER FLAP 8T
as default. You can change the device name
in the initial setting. Refer to Editing device
name on page 49.
•
PIN code is set to
0000
as the default. You
can change this code in the initial setting.
Refer to Entering PIN code for Bluetooth wire-
less connection on page 48.
Connecting and disconnecting
a cellular phone
Using a cellular phone to initiate a
connection
1
Display the connection menu.
Refer to Introduction of connection and regis-
tration on this page.
2
Use MULTI-CONTROL to select
8T HANDS FREE.
3
Use MULTI-CONTROL to select a group.
Push MULTI-CONTROL up or down to select a
group.
NOKIA (Nokia)-STANDARD (standard)
•
Normally select STANDARD. If the device of
Nokia is not paired to this unit, select NOKIA.
•
Push MULTI-CONTROL left or right to display
a group name or an 10.
4
Press MULTI-CONTROL to switch to
PAIRE FROM PHONE.
Push MULTI-CONTROL up or down to switch
PAIRE FROM PHONE and SEARCH DEVICE.
En
CID