Configuring The Network - Network Menu; Network Tab - Sony SNC-CH115 User Manual

Video port number 1, 2
Specify the transmission port number of the MPEG4/
H.264 video data. It is initially set to 50000.
Specify an even number from 1024 to 65534. Two port
numbers (the number specified here and an odd number
with 1 added to the specified number) are actually used
for video data communication and control.
The setting for Image 1 and Image 2 apply for Video port
number 1 and 2 respectively.
Note
Specify different numbers for the video port number.
Multicast streaming
Set whether the camera uses multicast streaming for
MPEG4/H.264 video data or not. It reduces the
transmission load on the camera by having a computer
of the same segment network receive the same
transmitting data.
Select On to allow, or Off not to allow multicast
sending.
When you select On, set Multicast address and Video
port number 1 and 2 properly.
Multicast address
Type the multicast address used on the multicast
streaming.
Video port number 1, 2
Specify the MPEG4/H.264 video transmission port
number used for the multicast streaming. It is initially
set to 60000. Specify an even number from 1024 to
65534. Two port numbers (the number specified here
and an odd number with 1 added to the specified
number) are used for video data communication and
control.
The setting for Image 1 and Image 2 apply for Video port
number 1 and 2 respectively.
Note
Specify different numbers for the video port number.
OK/Cancel
See "Buttons common to every menu" on page 32.
48
Configuring the Network — Network Menu
Configuring the Network
— Network Menu
When you click Network in the Administrator menu, the
Network menu appears.
Use this menu to configure the network to connect the
camera and the computer.
The Network menu consists of three tabs: Network,
QoS and Dynamic IP address notification.

Network Tab

This section provides the menus for connecting the
camera through the network cable.
MAC address
Displays the MAC address of this unit.
Ethernet status
Displays the current transmission rate.
This is displayed when the network change selection
switch is set to LAN. This is not displayed when it is set
to SLOC. (SNC-ZB550/ZM550/ZM551)
Auto-MDI/MDIX
According to the port of the connected Ethernet device,
automatically switches the port of the unit between MDI
and MDI-X for transmission.
Displays the Ethernet port mode of the unit.
This is displayed when the network change selection
switch is set to LAN. This is not displayed when it is set
to SLOC. (SNC-ZB550/ZM550/ZM551)