Firebox Cleaning; Maintaining Your Heater's Appearance - Monessen Hearth Direct Vent Gas Insert IDV380NVC Installation And Operating Instructions Manual

FIREBOX CLEANING

• Let logs cool before cleaning. Logs reach high temperatures.
• Make sure that clearances to combustibles leave enough room for maintenance
and service.
• Carefully reassemble and reseal insert properly after any cleaning or servicing.
1. Carefully remove log set, and embers from combustion chamber.
2. Vacuum burner compartment thoroughly.
3. Vacuum any dust off logs.
4. Remove any lint from main burner and pilot.
5. Carefully replace log set, and embers in their correct positions. See pages 21 through 23 .
6. Replace door.
7. Relight pilot. See page 28.
8. Turn on main burners.

MAINTAINING YOUR HEATER'S APPEARANCE

Fingerprints or other marks left on optional gold or nickel surface may become etched in place if they are not wiped clean
prior to turning stove on. Clean gold or nickel with a 50/50 vinegar and water solution and soft cloth.
NOTE: Make sure heater is cool before cleaning. Using cleaners other than a 50/50 vinegar and water
solution may leave a film that becomes permanently etched into the gold or nickel.
57D0016
CLEANING MAINTENANCE
AND
33