Replacing Mini-Card; Internal Card With Bluetooth ® Wireless Technology; Removing The Card - Dell 500 Owner's Manual

Replacing Mini-Card

NOTICE:
check the connectors on the card and on the system board, and realign the card.
NOTICE:
1 Insert the card connector into the system board connector at a 45-degree angle.
2 Press the other end of the card down into the slot on the system board
until the card clicks into place.
3 Replace the securing screw.
4 Connect the cables to the Mini-Card, ensuring that you route the cables
correctly.
5 Secure unused antenna cables in the protective mylar sleeve.
6 Replace the cover and tighten the eight captive screws.
Internal Card With Bluetooth
Technology
CAUTION:
safety instructions in the Product Information Guide.
NOTICE:
grounding strap or by periodically touching an unpainted metal surface (such as a
connector on the back of the computer).
NOTICE:
from the battery bay before you begin working inside the computer.
If you ordered a card with Bluetooth wireless technology with your computer,
it is already installed.

Removing the Card

1 Follow the procedures in "Before You Begin" on page 107.
2 Remove the hinge cover (see "Hinge Cover" on page 113).
3 Remove the screw securing the card.
122
Downloaded from www.Manualslib.com
The connectors are keyed to ensure correct insertion. If you feel resistance,
To avoid damage to the Mini-card, never place cables under the card.
NOTE:
For more specific information about which cable to connect to which
connector, see the documentation that came with your Mini-Card.
Before you begin any of the procedures in this section, follow the
To avoid electrostatic discharge, ground yourself by using a wrist
To help prevent damage to the system board, you must remove the battery
Adding and Replacing Parts
manuals search engine
®
Wireless