Connecting Via Bluetooth - ISOUND BT-200 User Manual

Connecting via Bluetooth® ( rst time
set-up)
1. Press and hold the power/phone bu on for at least 4
seconds to turn the headset on. You will hear a voice say
"Power on", then continue to hold the bu on until you
hear "Ready for pairing" and the LED power indicator will
rapidly ash blue and red.
NOTE: During the rst time set-up, you must hold the
power/phone bu on down until you hear a voice say
"Power on" then followed by "Ready for pairing" in order
to sync your device to Bluetooth. A er the initial pairing,
you can let go of the power/phone bu on a er you hear
"Power on".
2. Open the se ings on your Bluetooth device. (Bluetooth
must be enabled)
3. Select "BT-200" om the list of Bluetooth devices.
4. Once paired, you will hear a beep then a voice say
"Device connected". The LED power indicator light will
ash blue slowly.
5. To turn o the BT-200, press and hold the power/-
phone bu on for at least 5 seconds. You will hear a voice
say "Power o " before the headset turns o .
NOTES:
• Upon use of your BT-200 the volume must be adjusted
to your desired level, as the volume level has been
pre-set to the maximum.
• Your device will automatically nd and pair with the
BT-200 a er the initial pairing. If your device does not
automatically pair, you will hear a voice say "Pairing not
completed". Turn o the headset and repeat steps 1-4.