Advertisement
Chapter 2
Installation
Setting the DIP switches
First, set the DIP switches. The position of the switches depends on the application.
The drawing below shows the default positions of the DIP switches on the rear
panel of the switch.
Figure 1
All the DIP switches relate to the two 100 Mbps ports. A detailed explanation of
the DIP switches follows.
The DIP switches described below function only when the USE SWITCHES
switch is in the ON position.
•
LSV – Latest Software Version: The agent can use either the latest downloaded
software (the "Application" version), or a "Basic" version.
•
USE SWITCHES: Selects whether the 100Mbps functions will be controlled by
the DIP switches or from the management station.
When set to ON, 100 Mbps switch settings are determined by the DIP switches,
and can only be monitored, but not changed, by the console.
When set to OFF, the DIP switch settings are ignored and the 100 Mbps port
functionality is controlled from the console via the P110 NMA.
Set to ON when you don't have SNMP management, or when you want to
ensure that the settings will not be changed.
•
R12 – Redundancy: Setting this switch to ON enables redundancy. In this case,
port 1 is active and port 2 is redundant. In the event of link failure, switchover
to port 2 is automatic. Where redundancy is not desired, set this switch to OFF,
and both ports will operate normally.
P113F Stackable Switch Installation Guide
The P113F Stackable Switch Rear Panel Showing the DIP
Switches in their Default Positions
5
Advertisement
