Advertisement
3. Type the new IP address as shown in the example above and press Enter.
Leading zeroes may be omitted.
4. After the IP address is accepted, the Netmask prompt is automatically
displayed. The prompt has a default value based on the IP address.
5. Type the new Netmask value in the correct format or press Enter to accept the
default value.
6. Type 0 to return to the main menu.
Changes to IP Addresses and Netmasks require you to reset the agent. You
may reset the agent now, or at the end of the entire Setup session.
P113F Stackable Switch Installation Guide
Chapter 3
Configuration
27
Advertisement
