Installing The Anti-Tip Bracket - GE JSP46 Installation Instructions Manual

Installation Instructions

Installing the Anti-Tip Bracket

D
D1 Locating The Bracket
a. Decide whether the bracket will be
installed on the right or left side of range
opening.
b. Place the bracket as shown in Fig. 1.
E q
u a
E a
l S
c h
S i d
ADJACENT CABINET
FLOOR-WOOD
BRACKET
SIDE
REAR
LEVELING
LEG
FLOOR-CONCRETE
Fig. 1
p a
c e
e
L a
r g e
r T
h a
n 3
3 0 "
0 "
WALL
Installing The Bracket in Wood
D2
or Concrete
INSTALLATION–WOOD CONSTRUCTION
a. Locate the centers of the four holes identified
in Fig. 1 as Floor-Wood and Wall.
b. Drill a 1/8" pilot hole through the pre-marked
areas. Note the angle of the wall screw in
Fig. 2.
c. Mount the Anti-Tip bracket with the four
screws provided.
O p
TO FRONT EDGE
e n
i n g
OF
COUNTERTOP
INSTALLATION–CONCRETE CONSTRUCTION
a. For concrete installation you will need two
1/4"x 1-1/2" lag screws, and two sleeve
anchors.
b. Locate the center of the four holes identified
in Fig. 1 as Floor-Concrete and Wall. Drill
the recommended size holes in each.
c. Install the sleeve anchors into the predrilled
concrete holes and install the lag and wall
screws through the Anti-Tip bracket. Make
sure the screws are securely tightened.
8
ATTACHMENT TO WALL
25"
BRACKET
PLATE
SCREW MUST
ENTER WOOD
OR METAL
WALL
Fig. 2