Single Tone Selective Calling; Option Button Functions - Motorola GM350 User Manual

Single Tone Selective Calling

Single tone encode facilities are provided to enable
selective calling, or Repeater Access. Both models
may be enabled to initiate single tone selective
calls; however, only the 128-channel model only
may be enabled to receive single tone selective
calls.
Single Tone Encode - 4-channel and 128-
channel models
Subject to radio configuration, single tone selective
calling may be initiated automatically from the PTT
(11) or from a suitably programmed option button (6,
9).
Single Tone Decode - 128-channel model only
Subject to radio configuration, single tone selective
calling may be required to receive a message on
any pre-selected channel(s). When a selective call
is received, you will hear the Call Alert sounded
and the yellow LED (4) will flash.
Please contact the person in charge of your radio
system or your local Motorola representative for
further information.

Option Button Functions

Option Button Functions
The following functions may be applicable to your
radio, activated by one of the function/option
buttons.
Single Tone Encode - Single tone encode may
n
be initiated manually by pressing suitably
programmed option buttons.
Repeater Talkaround - This feature enables the
n
transmit frequency on a channel to be switched
to the same as the channel's receive frequency.
This will allow a radio to communicate directly
with another without the need to use a repeater.
Monitor - One option button (usually 5) may be
n
programmed as Monitor. This feature allows the
user to switch between different receiver settings
programmed as Receive, Monitor 1 and Monitor 2.
Scan (128-channel model only) - The scan
n
feature will cause the radio to search through
predefined lists of channels looking for a
condition that will cause the radio to unmute.
While searching for unmute conditions, the radio
is in 'active scan' (green LED flashing and Scan
icon on); having found the required conditions,
the radio will 'land' on the channel (green LED
off, Scan icon stays on).
Option Button Functions 5
English