Motorola Radius P110 Operating Instructions Manual page 22

P110 16-Channel Portable Radios
• Talkback Scan
This is an option of the channel scan features listed on
page 20 that is used when the PTT button is pressed
when scanning has stopped on a channel. When transmit
or receive activity ceases on a scan channel, a "hang
time" of approximately 3 seconds occurs prior to the radio
resuming scan for other channel activity. This "hang time"
gives you time to receive or respond to a call before scan-
ning resumes. The "hang-time" is programmable through
the Radio Service Software available at your local
Motorola Radius Dealer.
• Designated Channel Scan (Home Revert)
Pressing the PTT button while the radio is scanning
causes the radio to transmit on the preprogrammed desig-
nated channel location. This channel location is program-
mable through the Radio Service Software available at
your local Motorola Radius Dealer.
If both Designated Channel Scan and Talkback
Scan are selected, the radio transmits on the active
channel. If however, there are no active channels,
the radio transmits on the Designated Channel.
• Scan Talkback Tone
The Scan Talkback Tone feature enables you to find the
last active channel received during scan mode. A beep is
emitted when the channel selector knob is rotated to the
last channel received during scan.
• Scan Nuisance Delete
When a conversation occurs and it is not your priority
channel or designated scan channel, you can temporarily
eliminate this channel from the
scan list by pressing the side
Control button (if the Control but-
ton is programmed for Scan Nui-
sance Delete). To add the deleted
channel back to the pre-pro-
grammed scan list, you must exit
and reenter the scan function.
The Volume Set feature is replaced whenever
the side control button is programmed to oper-
ate the Scan Nuisance Delete feature.
May, 1997
Programmable Feature Enhancements
NOTE
NOTE
6880904Z68-O
21