Honeywell TH8320R1003 Installation Manual page 56

®
VISIONPRO 8000 WITH REDLINK™
ISU Installer Setup
Number Name
1402 Indoor -3° F to 3° F (in 1° F increments)
Temperature
Offset
1402 Indoor Humidity -12% to 12% (in 1% increments)
Offset
1404 Alert Light On
Indicator
Off
1500 Dealer Name
[Dealer Name]
1500 Dealer Phone [Dealer Phone]
1501 Dealer Email
[Dealer Email Address]
Address
1501 Dealer Website
[Dealer Website]
1502 Dealer Message [Dealer Message]
68-0312—03
Table 2. Installer Setup (ISU) Table. (Continued)
Settings Default
0° F
0%
On
None
None
None
None
None
56
Residential,
Commercial Requires
or Both EIM
Both No 0° F - No difference in displayed temperature
and the actual room temperature.
The thermostat displays up to 3°F (1.5°C)
lower or higher than the actual measured
temperature.
Both No 0% - No difference in displayed humidity and
the actual room humidity.
The thermostat displays up to 12% lower or
higher than the actual measured humidity.
Both No The thermostat has a built in light indicator.
When an alert is active, the light will be on
continuous if the thermostat is powered with
24 VAC (C wire) or it will flash if the
thermostat is powered with batteries only. The
light also turns on when the system setting is
set to Em Heat.
Select On to use the light indicator or select
Off to turn off the light.
Both No Dealer information is displayed to the user
when an alert is active and the user can
Both No
access this information by selecting "Dealer
Both No
Information" in the Menu.
Both No
Both No
Notes