Shutting Down - Panasonic CF-55 Series Operating Instructions Manual

Starting Up/Shutting Down
[Start] - [Suspend]
S u s p e n d M o d e
Power Switch
Do not touch the
power switch while
your computer is
entering the hiber-
nation mode.
Hibernation Mode
Power Switch
1 2

Shutting Down

Using the suspend function
Select [Start] - [Suspend]
Using the hibernation function
It is necessary to set the hibernation function using the Setup Utility.
1
Run the Setup Utility
2
Using and
3
Using and
, then press
4
Close the Setup Utility
C A U T I O N
Save all data before powering off your computer.
When restarting from or shutting down to the suspend or hibernation mode, do not
touch the mouse (serial or PS/2 type). There are cases where the mouse will fail to
operate; you will have to restart your computer using the keyboard (
Do not power off during the following periods (you may corrupt your data or file):
• While the FDD indicator (
on.
• While playing/recording audio files.
• While communications software is being used.
Do not use the suspend or hibernation function when using an OS other than Win-
dows 95, the diagnostics program (DIAG55), or the Setup Utility, or when experienc-
ing static electricity or noise.
If you hold down on the
enter the suspend or hibernation mode, after resuming operation, you must press the
same key. For example, if you hold down on the
switch, upon resuming, if you do not press the
will result from typing.
If your computer locks up, press the reset button. All data is lost when this button is
pressed.
When a file in an external device such as an external hard disk or ATA card is opened,
the suspend or hibernation function may not work. In such cases, close the file.
SCSI cards may not recover properly after entering the suspend or hibernation mode.
If this occurs, restart the computer.
R e s u m i n g O p e r a t i o n
If [Enter Password:] or
been set ( page 10).
C A U T I O N
Do not install or remove peripherals while your computer is in the suspend or hiberna-
tion mode; abnormal operation may result.
When operation resumes, serial devices such as a mouse or modem, or your PC Cards
may not work. In such cases, you will need to restart your computer or reinitialize the
individual devices.
( page 34)
, select [Power Management] then press
, select [Power Switch], set [Hibernation] with
( page 34)
), HDD indicator (
, or key while pressing the power switch to
is displayed upon pressing the power switch, your password has
page 11).
) or CD-ROM indicator (
key while pressing the power
key again, only capital letters
) is