Computer Diagnosis - Panasonic CF-55 Series Operating Instructions Manual

Computer Diagnosis

List of Error Codes
C o d e
062 Boot failure--default configuration used
101 System Board Failure
102 System Board Failure
106 System Board Failure
114 Adapter ROM Error
151 System Board Failure
161 Bad CMOS Battery
162 Configuration Change Has Occurred
162 Configuration Error
163 Date and Time Incorrect
173 Configuration Change Has Occurred
201 Memory Size Error
301 Keyboard Error
303 Keyboard Error
604 Diskette Drive Error
605 Diskette Drive Error
1780 Hard Disk Error
1800 PCI Error
1801 PCI Error
1802 PCI Error
1803 PCI Error
1804 PCI Error
1805 PCI Error
8601 Pointing Device Error
I9990301
I9990305
Using the Self-diagnosis Program
If a problem occurs with your hardware, [POST Start up Error(s)] is displayed along with the
error code(s), follow the on-screen instructions.
Setup utility ( page 34) is started. Run [Load Default Settings (PnP)].
:
S e t u p
Next the Setup Utility must be run again to input the appropriate operating environ-
ment settings.
Ignore the error message(s), and restart the computer.
Exit :
Follow the procedure below to check whether each part of your computer is operating properly.
1
To run the program, insert the Firstaid FD you created into the
floppy disk drive, then turn your computer on
2
When the display below is shown, select [1. Boot]
1. Boot
2. Restore HDD to factory default (For beginners)
3. Restore HDD to factory default (For advanced users)
3
At the MS-DOS prompt (A:\WINDOWS\COMMAND>), input the
following:
diag55
Follow the messages on the screen.
D e s c r i p t i o n
Default configuration in use
Interrupt controller failure
Timer 2 test failure
Diskette controller failure
Adapter ROM checksum error
Real-time clock failure
Dead battery
Configuration error
CMOS checksum error
Real-time clock is not updating
ROM configuration has changed
Memory size/data error
Keyboard failure
Keyboard controller failure
Diskette drive 0 configuration error
Diskette unlocked problem
Fixed disk 0 failure
No more IRQs available
No more room for optional ROM
No more I/O space available
No more memory (above 1 MB) available
No more memory (below 1 MB) available
Checksum error or 0 size optional ROM
Pointing device failure
Hard disk failure
An operating system could not be found
2 3