Firmware Upgrade - Philips EXP210 Service Manual

CONNECTIONS AND CONTROLS
EXP51x
9
0
!
@
#
$
%
^
&
*
(
1 OPEN 2 ..........opens the CD lid
2 VOL E..........adjusts the volume
3 ...................marks and unmarks a favourite
4 ∞ ....................skips backward and searches backward
5 § ....................skips forward and searches forward
6 – ......................MP3-CD only: selects the previous album or
skips backward
7 + ......................MP3-CD only: selects the next album or skips
forward
8 DBB/TREBLE..selects the bass and treble adjustment
9 ESP.................Electronic Skip Protection prevents music
interruptions caused by shocks or vibrations
0 ........................display
! MODE .............selects playback options such as
REPEAT
@ DISPLAY.........selects the track and album information
# 9 .....................stops playback and switches the set off
$ 2; ...................switches the set on, starts playback and
interrupts playback
% RESUME.........stores the last position played
HOLD ..............locks all buttons
OFF.................switches RESUME and HOLD off
^ .................selects playback of favourites
& LINE OUT/p ....3.5mm line out to connect
- the headphones
- the remote control
- this set to the audio input of your stereo
equipment
* 4.5V DC ..........to connect the external power supply
( ........................battery compartment
) ........................type plate
¡ ........................belt clip hole
1-3
FIRMWARE UPGRADE (EXP51x only)
Occasionally, Philips releases new software ("firmware") for your
set.
8
1 Connect the mains adapter to 4.5V DC on the set and to the wall
7
socket.
6
2 Keep MODE pressed for 3 seconds.
5
→ The type of your set and the current version of the firmware
4
are displayed. Upgrade? is displayed.
3
3 Press 9.
4 Visit the Philips Audio homepage www.audio.philips.com. Check
if there is a firmware file for your set and if the firmware version is
higher than the current version of your set. Download the file and
burn it on a CD-ROM.
2
5 Insert the CD-ROM into the set and keep MODE pressed for 3
1
seconds.
→ Upgrade? is displayed.
6 Press 2;:
→ Upgrading is displayed and upgrading starts. This may take
some minutes. After upgrading is finished, Upgrade complete
is scrolled.
→ Wrong upgrade file is scrolled: Your set already has the
latest firmware or the downloaded file does not correspond to
¡
your set.
→ Upgrade file defect is scrolled: The upgrade file has been
damaged during the download or when burning the CD-ROM.
Download the file again, burn a new CD-ROM and try again.
)
→ No upgrade file is scrolled: No upgrade file was found on the
inserted CD-ROM.
Note: If upgrading is interrupted accidentally, repeat step 6 until
upgrading is completed successfully.
and
SHUFFLE