With Floor Nozzle - Shark NV351 Owner's Manual

Above-Floor Cleaning
a
Fig. 15
Suction
Release Collar
CLEAN ABOVE THE FLOOR IN UPRIGHT VAC OR
DETACHABLE CANISTER MODE
1
Press the handle release button and pull the handle
up or press the extension wand release button and
pull the extension wand up.
2
Attach desired accessory onto the end of either the
extension wand or the handle. (Fig. 15)
(*Pet Upholstery tool only for models NV351 & NV352
**Pet Power Brush only for model NV353
***24" Crevice only for model NV352 )
3
Your vacuum has tremendous suction power.
Adjust the amount of suction with the suction
release on the handle. Open the valve (a) by
rotating the collar 90˚ counterclockwise for low
suction when doing light jobs such as drapes or
fine surfaces. Close the valve (a) by rotating the
collar clockwise 90˚ for high suction and when
using the hand held accessories. (Fig. 15)
4
Press the On/Off switch to the "I" position to turn
the vacuum on for above-floor cleaning.
IMPORTANT: Ensure vacuum is in upright position.
Do not use position "II" when cleaning above the
floor in the upright vac mode as this will engage
the motorized floor brush. The rotating brush may
damage your floor if run for a prolonged period of
time in one area.
*
**
***
Release suction
for easier push &
pull on high pile
carpets and area
rugs.

With Floor Nozzle

Fig. 16
CLEAN THE FLOOR IN DETACHABLE CANISTER
MODE
1
Press the extension wand release button and pull
the extension wand up.
2
Attach either floor nozzle onto the end of the
extension wand. (Fig. 16)
3
Press the On/Off switch to the "I" position to turn
the suction motor on.
NOTE: The rotating brush will not rotate in
Detachable Canister mode.
www.sharkclean.com 15