Advertisement
91-5676-10-00_E262Manual_R0FEB2704.qxd
Battery & charger installation
After installation, place the handset in the charger and allow the battery to charge for 12
hours before use. You can keep the battery charged by returning the handset to the charger
after each use. When battery power is fully depleted, a full recharge takes about 8 hours.
Press coin into slot on
base of handset to
release latch, then
remove cover.
Insert top
tab first.
Caution: Use only the supplied NiCd battery
(model 2403) or AT&T NiMH replacement battery
(model 2401).
2/27/2004
Plug power cord into jack on under-
side of charger, then plug transformer
into electrical outlet.
Press down to
click in place.
2
12:41 PM
Page 2
LOW BATTERY
RDL
MENU
Low battery indicator
Return handset to charger when this
symbol flashes. (Handset will beep
when battery is low.)
Insert supplied
battery.
Place handset in charger for
12 hours before first use.
Light remains on while
battery is charging.
MEM
Advertisement
