Resetting The Base To The Default Settings; Repeater Mode - Gigaset A400 User Manual

Resetting the base to the default
settings
When restoring factory settings:
u Individual settings are reset
u All lists are deleted
Only the date and time are retained.
Software reset
Menu ¤ Settings ¤ OK ¤ Base ¤ OK ¤ Base Reset ¤ OK
¤ Reset? ¤ OK
Hardware reset
Additionally
u All handsets are deregistered and
u The system PIN is reset to the original code 0000.
Disconnect the power cable from the base. Hold
down the registration/paging key (¢ page 1) on the
base and reconnect the power cable to the base at
the same time. Release the key after approximately
5 seconds.

Repeater mode

With a repeater you can increase the range of your
base. You will need to activate repeater mode
(¢ page 15). Repeater mode and Eco Mode or Eco
Mode+ (¢ page 1) cancel each other out. The default
encrypted transmission setting is deactivated when
repeater mode is activated.
After activating or deactivating the repeater, switch
your handset off and on again (¢ page 6).
11
Operating the base on the
PABX
The following settings are only necessary if your PABX
requires them, see the user guide for your PABX.
When entering the digits, enter them slowly one after
the other.
Changing the dialling mode
P#Q5#11
MENU ¤
set dialling mode flashes: 0 = tone dialling (DTMF);
1 = pulse dialling (PD) ¤
Setting recall
P#Q5#12
Menu ¤
the current recall flashes
2 = 120 ms; 3 = 400 ms; 4 = 250 ms; 5 = 300 ms;
6 = 600 ms; 7 = 800 ms ¤
Changing the pause after line seizure
You can set the length of the pause inserted between
pressing the accept key
phone number.
P#Q5#1O
Menu ¤
the current pause length flashes: 1 = 1 sec.; 2 = 3 sec.;
3 = 7 sec. ¤
Enter number
Changing the pause after recall key
P#Q5#14
Menu ¤
current pause length flashes
3 = 3200 ms ¤
Enter number
¤ The number for the
¤ OK.
enter number
¤
The number for
: 0 = 80 ms; 1 = 100 ms;
¤ OK.
Enter number
c
and transmitting the
¤ The number for
¤ OK.
¤ The number for the
:
1 = 800 ms; 2 = 1600 ms;
¤ OK
.