Remote Control - Sanyo D32830H Owner's Manual

USING THE MULTIMEDIA REMOTE CONTROL
Operates your TV, VCR, DVD, Cable converter box, and Satellite Receiver. To program
the remote control, see pages 9 ~ 11.
INSTALL BATTERIES AS SHOWN (2 AA, not included)
Notes:
– Do not mix old batteries with new ones or mix different types of
batteries together.
– Remove the batteries if the remote control will not be used for a
month or more. Weak batteries may leak and cause damage.
(Normal battery life is roughly six months.)
IMPORTANT NOTE: Spent or discharged batteries must be recycled or disposed
of properly in compliance with all applicable laws. For detailed information,
contact your local County Solid Waste Authority.
REMOTE CONTROL KEYS
Mode Keys—Use these keys to program the remote
control and to select the operating mode (VCR, TV,
CABLE, DVD, SAT, or AUX). To Operate Your...
VCR—Press the VCR key; Television—Press the
TV key; Cable Box—Press the CABLE key; DVD
Player—Press the DVD key; and Satellite
Receiver—Press the SAT key.
Note: Make sure you hold down the mode key
while entering a code number, see page 9.
Input Key—In the TV, DVD, Cable, and Satellite
modes, this key selects the program source to
display on the screen (TV signal or signal from
equipment connected to the AV jacks). In the VCR
mode, this key functions as a VCR's TV/ VCR key.
Number Keys—Two keys must be pressed to select
a channel. Example: Press 0 then 6 to select channel 6.
For cable channels 100 through 125, press and hold the
1 key until C1–– appears. Then press the other two
numbers.
Caption Key—See page 15.
Menu Key—Use this key with the
keys to navigate and adjust features of the on-screen
menu system (see pages 12 ~ 14).
and – /+
/
VCR TV CABLE
DVD SAT AUX
POWER
INPUT RESET
1 2 3
4 5 6
7 8 9
0
CAPTION SLEEP
MENU RECALL
CH
VOL VOL
CH
MUTE DISPLAY
(Continued on page 8.)
QuickTips
Be sure batteries are
installed correctly.
Point the remote
control toward the
equipment you want to
operate. Objects bet-
ween the remote
control and the equip-
ment may cause
misoperation of the

remote control

function.
If the remote control
does not work: Press
TV key (see item 1).
The remote control
must be programmed
before it will operate
your VCR, DVD
Player, Satellite
Receiver, or Cable
Box. See pages 9~11.
Note: Sanyo VCR
and DVD codes are
preprogrammed.
Cannot select
channel with number
keys. Press "0"in
front of numbers 1~9.
Example: Channel 05.
Adjusting the volume
level: Flashing Right
arrow indicates
volume is increasing
and flashing Left
arrow indicates
volume is decreasing.
Need help?
Visit our Web site at
www.sanyoctv.com
or Call 1-800-877-5032
7