Eye Cup, Evf Fulcrum, Evf Case U, Evf Case B, Eblb Circuit Board, Evf Lcd, And Evf Backlight - Hitachi DZ-MV230A Service Manual

4.11 Eye cup, EVF fulcrum, EVF case U, EVF case B, EBLB circuit board, EVF LCD, and EVF
backlight (Fig. 4-11)
Caution when disassembling:
Be careful not to damage the EVF LCD or EVF backlight.
Eyecup (A)
(1) Release the tab, and then remove the eye cup in the direction of the arrow.
EVF fulcrum (B), EVF case U (C)
(2) Remove the four screws holding the EVF fulcrum, and then remove the EVF fulcrum.
(3) Remove the EVF case U in the direction of the arrow.
EVF case B (D), EBLB circuit board (E), EVF LCD (F), EVF backlight (G)
(4) Remove the EVF LCD block (H) from EVF case B, and then release the two tabs on LCD holder cover (J).
(5) Release the two tabs, and then remove the EBLB circuit board.
(6) Disconnect the two flat cables on EBLB circuit board.
(7) Remove the EVF LCD and EVF backlight from LCD holder (K) in the direction of the arrow.
A : Eyecup
B : EVF fulcrum
C : EVF case U
D : EVF case B
E : EBLB circuit board
F : EVF LCD
G : EVF backlight
H : EVF LCD block
J : LCD holder cover
K : LCD holder
L : Clear cover
M : EVF connection cable
2 - 18
(3)
J
(5)
G
(7)
K
(6)[Type-b]
E
M
(2)
Fig. 4-11
C
H
(4)
(1)
A
F
L
(1)
D
B
(2)