Samsung NC241 User Manual page 45

2
Using "PCoIP"
Display Tab
The Display page lets you enable the
This function is only available through the OSD.
Under normal operation, the
determine the monitor's capabilities. In some situations, a monitor may be connected to a client in a way
that prevents the client from reading the
KVM devices.
The options in this page configure the client to advertise default
Enabling display override forces the default monitor display information to be used which may not be
compatible with the connected monitor resulting in a blank monitor. Only enable display override when
there is no valid EDID information and monitor display characteristics are known.
Figure 2-12: Display
Enable Attached Display Override

This option is intended for legacy systems. It configures the client to send default
to the host when a monitor cannot be detected or is not attached to the client. In versions of
Windows prior to Windows 7, once the host had no
were attached and would never recheck. This option ensures that the host always has
information when the client is in session.
The following default resolutions are advertised when this option is enabled:
800 x 600 @ 60 Hz

1024 x 768 @ 60 Hz (native resolution advertised)

1280 x 800 @ 60 Hz

1280 x 960 @ 60 Hz

Extended Display Identification Data(EDID)
GPU in the host computer queries a monitor attached to the zero client to
EDID information, such as when connecting through certain
Configuration
EDID information to the GPU.
EDID information, it would assume no monitors
2 Using "PCoIP"
override mode.
EDID information
EDID
45