Ec Declaration Of Conformity - Husqvarna TS 350E Operator's Manual

EC declaration of conformity

Husqvarna AB, SE-433 81 Göteborg, Sweden, tel: +46-
31-949000, declares under sole responsibility that the tile
saw Husqvarna TS 350 E dating from 2010 serial numbers
and onwards (the year is clearly stated on the rating plate,
followed by the serial number), complies with the require-
ments of the COUNCILíS DIRECTIVE:
• of May 17, 2006 "relating to machinery" 2006/42/EC
• of December 15, 2004 "relating to electromagnetic
compatibility" 2004/108/EC.
• of December 12, 2006 "relating to electrical equip-
ment" 2006/95/EC.
•
of May 8, 2000 "relating to the noise emissions in the
environment" 2000/14/EC. Conformity assessment
according to Annex V.
•
of June 08, 2011 on the 'restriction of use of certain
hazardous substances' 2011/65/EU.
The following standards have been applied: EN ISO
12100:2010, EN 55014-1:2006, EN 55014-2/A1:2001, EN
61000-3-2:2006, EN 61000-3-11:2000, EN 12418+A1:2009.
Gothenburg 12 April 2015
Helena Grubb
Vice President, Construction Equipment Husqvarna AB
(Authorized representative for Husqvarna AB and
responsible for technical documentation.)
The Equipment ful lls the requirements in EN61000-3-11
and is subject for conditional connection to the mains. It
may be connected in consultation with the supply author-
ity. The equipment will only be connected to the mains
supply with impedance lower than 0,49 Ohm. The system
impedance at the interface point may be obtained from
the supply authority.
If the mains supply has higher system impedance, short
voltage dips may appear when the equipment is started.
This may in uence the operation of other apparatuses, e.g
ickering lights.
10
- Polish
Operator's manual - TS 350 E