Table of Contents
Advertisement
3.9.
Replacement of Speaker Connector Housing (For SB-MAX500LMK)
For Speaker wire connection, please refer to 1.2. Speaker setup
3.9.1.
Disassembly of Speaker Connector Housing
Step 1: Insert a paper clip & push the Wire terminals outwards.
Step 2: Detach the (+) and (-) speaker wire.
3.9.2.
Assembly Disassembly of Speaker
Connector Housing
Step 1: Slightly lift up the wire terminals approximately 45° as
shown.
Step 2: Insert the (+) speaker wire into the (+) hole of the
Speaker Connector Housing.
Step 3: Push in the speaker wire until hear the "click" sound.
Step 4: Insert the (-) speaker wire into the (-) hole of the
speaker connector housing.
Step 5: Push in the speaker wire until hear the "click" sound.
Step 6: Pull both speaker wires gently to ensure they lock-in
firmly.
Note: Repeat these procedures if the speaker wires come out.
Advertisement
Table of Contents
