Making/Answering Calls; Making Calls - Panasonic KX-TG4711C Operating Instructions Manual

Making/Answering Calls

Making calls

Using the handset
1
Lift the handset and dial the phone
number.
R To correct a digit, press MCLEARN.
2
Press M N or MCALLN.
3
When you finish talking, press MOFFN or
place the handset on the base unit or
charger.
Using the speakerphone
1
Dial the phone number and press M
R Speak alternately with the other party.
2
When you finish talking, press MOFFN.
Note:
R For best performance, use the
speakerphone in a quiet environment.
R To switch back to the receiver, press M
M N.
Adjusting the receiver or speaker
volume
Press MjN or MkN repeatedly while talking.
Note:
R There are 5 volume levels (1 to 5) for the
receiver. When you change the receiver
volume to level 5 (maximum level), the
volume returns to level 4 (default) after you
hang up.
Making a call using the redial list
The last 5 phone numbers dialed are stored in
the redial list (each 48 digits max.).
1
MREDIALN or MEN REDIAL
R If there is a new message in the Voice
Mail or answering system, MREDIALN
is not displayed.
2
MbN: Select the desired phone number.
3
M N
16
TG47xxC(en)_1212_ver021.pdf
Erasing a number in the redial list
1
2
3
4
Using the base unit
Available for:
KX-TG4741 series (page 3)
1
2
N.
3
4
Note:
N/
R For best performance, use the
R While on a call, you can switch from the
Adjusting the speaker volume
Press MjN or MkN repeatedly while talking.
Redialing the last number dialed
MSP-PHONEN a MREDIALN
Pause (for PBX/long distance
service users)
A pause is sometimes required when making
calls using a PBX or long distance service.
When storing a calling card access number
and/or PIN in the phonebook, a pause is also
needed (page 22).
16
MREDIALN or MEN REDIAL
MbN: Select the desired phone number.
a MERASEN
MbN: "Yes" a MSELECTN
MOFFN
MSP-PHONEN
Dial the phone number.
When the other party answers, speak into
the microphone.
R Speak alternately with the other party.
When you finish talking, press
MSP-PHONEN.
speakerphone in a quiet environment.
base unit to the handset:
– Press M N on the handset, then press
MSP-PHONEN on the base unit with the
privacy mode off (page 26).
– If the handset is on the base unit, simply
lift it.
2011/12/12 14:19:41