BMW X1 2015 Owner's Manual page 194

Mobility
4. Slide the sealing container upright into the
holder on the compressor housing, ensur‐
ing that it engages audibly.
5. Screw the connection hose onto the tire
valve of the nonworking wheel.
6. With the compressor switched off, insert
the plug into a power socket inside the ve‐
hicle.
194
Wheels and tires
Online Edition for Part no. 01 40 2 964 303 - VI/15
7. With the ignition turned on or the engine
running, switch on the compressor.
CAUTION
The compressor can overheat during ex‐
tended operation. There is risk of property
damage. Do not run the compressor for more
than 10 min.◀
Let the compressor run for approx. 3 to 8 mi‐
nutes to fill the tire with sealant and achieve a
tire inflation pressure of approx. 2.5 bar.
While the tire is being filled with sealant, the
tire inflation pressure may sporadically reach
approx. 5 bar. Do not switch off the compres‐
sor at this point.
If a tire inflation pressure of 2 bar is not
reached:
1. Switch off the compressor.
2. Unscrew the filling hose from the wheel.
3. Drive 33 ft/10 m forward and back to dis‐
tribute the sealant in the tire.
4. Inflate the tire again using the compressor.
If a tire inflation pressure of 2 bar cannot be
reached, contact your dealer's service cen‐
ter or another qualified service center or
repair shop.
Stowing the Mobility System
1. Remove the connection hose of the seal‐
ant container from the wheel.
2. Remove the connection hose from the
sealant container.