Avaya 8410B Manual page 8

Guide Builder Document
Note: Before you can use this feature, AD buttons must first be assigned by your system manager. (These AD locations can be assigned to actual buttons.)
If you hear the intercept tone while programming, start over from the beginning.
To program or reprogram an AD button:
1. On a separate sheet of paper, write down the outside numbers, extensions, and/or feature access codes you want
to program.
Note: Each AD button will hold one complete phone number or feature access code.
2. Pick up the handset.
3. Press Program.
or, Dial the Program code *49.
4. Press the AD xxxxx button to be programmed.
5. Dial the phone number, extension, or feature access code you want to store (up to 24 digits).
Note: If you are programming an outside number, be sure to include a trunk code, if applicable.
6. Press #.
The number is stored.
7. If you want to program another button, repeat Steps 4 through 6.
8. Hang up or press Drop to end programming.
To place an AD call:
1. Press the selected AD xxxxx button.
The call is automatically dialed.
To program a number into a personal list:
1. On a separate sheet of paper, write down the outside numbers, extensions, and/or feature access codes you want
file://C:\Program Files\gbuilder32\win\~5334240.htm
Page 8 of 31
{dial tone}
{dial tone}
{dial tone}
{confirmation tone}
{ringback tone}
7/24/2005