Selecting Memory - Sanitas SBM 42 Instructions For Use Manual

✘
Please ensure that the cuff is not bent at any point and
that the reinforced end lies flat against your arm.
Adopt the correct posture
• Before every measurement, relax for about five minutes.
Otherwise deviations can occur.
• You can perform the measurement while sitting or lying.
Make sure that the cuff is at heart level.
• To carry out a blood pressure measurement, make sure
you are sitting comfortably with your arms and back lean-
ing on something. Do not cross your legs. Place your feet
flat on the ground.
• To avoid falsifying the measuring result, it is important to
remain still during the measurement and not to speak!

Selecting memory

✔
Press the - or + function button. Select the desired user
memory (
You have 4 memories with 30 spaces each to store the
measurements of 4 different people separately. Confirm
your selection with the START/STOP button
Performing the blood pressure measurement
• As described before, attach the cuff and adopt the pos-
• Start the blood pressure monitor with the START/STOP
• The cuff automatically inflates. The cuff's air pressure is
• Systolic pressure, diastolic pressure and pulse readings
• Measuring can be cancelled at any time by pressing the
•
8
... ) by pressing the -/+ function button.
ture in which you want to perform the measurement.
button . After the full-screen display, the most recently
stored measurement appears. If there is no measurement
in the memory, the unit displays the value "0".
slowly released. If the device already recognise a ten-
dency for high blood pressure, it will reinflate and increase
the cuff pressure again. As soon as a pulse is found, the
pulse symbol is displayed.
are displayed.
START/STOP button .
_ appears if the measurement has not been performed
properly. Take note of the chapter on error messages/
trouble-shooting in these instructions for use and repeat
the measurement.
.