Panasonic DMR-BWT850 Operating Instructions Manual page 91

Messages on the front panel display
The following messages or service numbers appear on the
front panel display when something unusual is detected.
BD
("∑" stands for a number.)
The remote control and main unit are using different codes.
Change the code on the remote control. (
CONV
Selected titles in the USB HDD are being converted.
Do not disconnect the USB HDD from this unit.
GUIDE
TV Guide data is being downloaded.
NoERAS
You cannot delete items on this disc.
The disc may be damaged.
NoREAD
• The disc is dirty. ( 10) The unit cannot record, play, or
edit.
• The lens cleaner has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to eject the disc.
NoWRIT
You cannot write to this disc.
The disc may be damaged. Use a new disc.
PLEASE WAIT
• Displayed when the unit is started and is switched to
standby mode.
• There was a power failure or the AC plug was disconnected
while the unit was on. The unit is carrying out its recovery
process. Wait until the message disappears.
PROG FULL
There are already 32 timer programmes. Delete unnecessary
timer programmes. ( 33)
REMOVE
The USB device is drawing too much power. Remove the
USB device.
START
Update of the software (firmware) is started.
You cannot operate the unit until the update is complete.
( 81)
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or the timer
recording starts. (
When "FINISH" is displayed, update of the software
(firmware) has completed.
UNSUPPORT
86)
The media is not supported.
UPD /
("∑" stands for a number.)
The software (firmware) is being updated.
You cannot operate the unit until the update is complete.
( 81)
U59
The unit is hot.
The unit switches to standby for safety reasons. Wait for
about 30 minutes until the message disappears.
Install or place this unit with good ventilation.
U61
(When a disc is not inserted) A malfunction has occurred. The
unit is trying to restore to the normal operation. Once the
message disappears you can use the unit again.
If it remains displayed, consult the dealer.
U76
HDMI cannot be output because it is connected to a model
that does not support copyright protection.
U77
Due to the current disc not having authorised copyright
information, video output is not performed.
U88
(When a disc is inserted) There was something unusual
detected with the disc or the unit. The unit is trying to restore
to the normal operation. Once the message disappears you
can use the unit again.
If it remains displayed, consult the dealer.
U99
The unit fails to operate properly. Press [Í/I] on the main unit
to switch the unit to standby mode. Now press [Í/I] on the
main unit again to turn the unit on.
X HOLD
The HOLD function is activated. (
Troubleshooting
81)
84)
SQT1119
91