Panasonic DMR-BWT850 Operating Instructions Manual page 87

TV screen and video
Screen size is wrong.
• Check the "TV Aspect" or "Aspect for 4:3 Video".
( 75)
• Adjust the aspect ratio setting on TV.
• Adjust the aspect ratio setting on this unit.
( 85)
• Check "Aspect for Recording" before recording
or file conversion. (
The black screen appears on the TV.
• This phenomenon may occur, depending on the TV
setting, when "Quick Start" is activated. Depending on
the TV, this phenomenon may be prevented by
reconnecting to a different HDMI input terminal.
TV reception is not displayed.
• Broadcast signals are not output from this unit's
RF OUT terminal. Select "On" in "RF OUT
( Aerial Signal )". (
The screen changes automatically.
• If "Screen Saver" is set to "On", the screen saver
function will be activated when there is no
operation for 5 minutes or more. (
There is a lot of image lag when playing video.
• Set to "0" all items in the "Noise Reduction". (
• Set "Audio Delay". (
The images do not appear on the TV.
The picture is distorted during play, or video
is not played correctly.
• Check the connections. (
• Check the settings of the connected TV, etc.
• An incorrect resolution is selected in "HDMI
Video Format". ( 75) Reset the setting as
follows:
1 While the unit is on, press and hold [OK], the
yellow button and the blue button at the
same time for more than 5 seconds.
• "00 RET" is displayed on the front panel
display.
72)
79)
75)
75)
14)
2 Repeatedly press [1] (right) until "04 PRG"
is displayed on the front panel display.
3 Press and hold [OK] for at least 3 seconds.
Set the item again.
• When Dolby Digital Plus, Dolby TrueHD,
and DTS-HD
properly, select "Yes" in "Default Settings"
and make proper settings. (
• The unit's TV System is different from that of the
disc. Change the TV System. (
• The picture may be distorted or a black screen
may appear between scenes recorded with
different aspect ratios.
• Set "Deep Colour Output" (
Type Flag" (
3D video is not output correctly.
• 3D video may be output correctly by changing
the following settings:
- "3D Type" of "3D Settings" (
- "Signal Format" (
playback)
• Check the settings of the connected TV.
• When a non-3D compatible amplifier/receiver is
connected between this unit and a TV, 3D video
is not output. (
• When "HDMI Audio Output" is set to "Off", 3D
video may not be output correctly. (
Sound
69)
No sound.
Distorted sound.
• Check the connections. (
• Check the settings of the connected TV, etc.
• Select the audio with "Multi Audio". (
• To output audio from a device connected with an
HDMI cable, set "HDMI Audio Output" to "On".
( 76)
Cannot change audio channel.
• You cannot change the audio channel if "Digital
Audio Output" is set to "Bitstream" (
Troubleshooting
audio are not output
®
80)
75, TV System)
76) or "Contents
76) to "Off".
75)
41, 3D settings during
15)
14)
SQT1119
76)
22, 40)
74)
87