Device Description - Dimplex SRX 070 ECM Installation And Operating Insctructions

1. Information for the user
NOTE NOTE
Dear customer,
To ensure safe operation, the heater may only be in-
stalled and connected in accordance with these instal-
lation and operating instructions. Read all information
contained in this manual carefully. Keep these instruc-
tions in a safe place and pass them on to any new
owner.
ATTENTION!
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical,
capabilities or lack
knowledge if they have been given super-
vision or instruction concerning the use of the
appliance in a safe way and understand the
hazards involved. Children shall not play with
the appliance. Cleaning and user main-
tenance shall not be made by children without
supervision!
ATTENTION!
Children of less than 3 years should be kept
away unless continuously supervised!
ATTENTION!
Children aged from 3 years and less than 8
years shall only switch on/off the appliance
provided that it has been placed or installed
in its intended normal operating position and
they have been
instruction concerning
appliance in a safe way and understand the
hazards involved!
ATTENTION!
Children aged from 3 years and less than 8
years shall not plug in, regulate and clean the
appliance or perform user maintenance!
ATTENTION!
Some parts of this product can become very
hot and cause burns! Particular attention has
to be given where children and vulnerable
people are present!
ATTENTION!
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard!
www.dimplex.de/en
sensory or mental
of experience
given supervision
the use of the
SRX_C_gb · 09/15/B
SRX 070ECM, SRX 120ECM, SRX 160ECM
ATTENTION!
The heater must not be located above or
below a socket outlet!
ATTENTION!
In order to avoid overheating, do not cover the
heater!
ATTENTION!
The heater carries the warning symbol
indicating that it must not be covered!
ATTENTION!
Install the device such that it is not possible
or
for someone in the bath or shower to touch
the control element!
The installation of this heater must be carried out

by a competent electrician in accordance with the
current safety regulations.
The heater may only be used for heating room air in

enclosed spaces.
In the event of any defect or during extended peri-

ods of non-use, the heater must be disconnected
from the power supply. Deactivate or remove fuse.
The outside of the appliance gets hot when in use.

Do not use the appliance in areas where flammable

gases or liquids are stored or used.

2. Device description

The SmartRad model is a fan convector for heating living
spaces. The fan convector is intended for connection to a
central heating system. The fan convector is suitable for
or
use in heat pump systems, but it can also be operated in
conjunction with other heating systems, e.g. with oil or gas
fires. The device draws in air from the underside. This is
heated up in the heat exchanger and discharged at the
top.
Figure 1:
(a) Casing cover
(b) Control panel
(c) Air outlet guard
(d) 1 m connection cable
Fan convectors may only be used in central heating
systems with a closed control circuit.
The heating system must be operated as a dual-pipe
system.
The devices must be of a sufficient rating such that
they can compensate for heat losses in the room.
The cooling function will only work in suitable systems,
e.g. in combination with a reversible heat pump with
both heating and cooling modes.
EN-17