Disk Configuration; Format - Honeywell HRDP H.264 Rev B User Manual

Hide thumbs Also See for HRDP H.264 Rev B:

Table of Contents

Setup

Disk Configuration

______________________________________________________________________________________________

Shows installed Hard Disk Drives and the status of other attached storage

devices.

To format a Hard Drive use the arrow keys to select the appropriate device

and press ENTER. Select FORMAT and press ENTER, select YES to confirm

formatting and press ENTER.

To format a USB device use the arrow keys to select the device and press

ENTER. Select Format and press ENTER. Select YES to to confirm and press

ENTER.

Tip

Refer to the list of Approved USB Flash Drives in the Introduction

chapter.

To refresh the list of connected USB devices select RESET and press ENTER.

Caution All USB devices must be formatted as FAT32 before using with the

DVR.

Note

Upon formatting a drive, all video and other data stored on that

drive will be permanently erased and cannot be recovered.

Table of Contents